Re: KX1 ATU problem
Posted by
Don Wilhelm-4 on
Dec 11, 2009; 10:34pm
URL: http://elecraft.85.s1.nabble.com/KX1-ATU-problem-tp4149575p4154175.html
Is it possible that you upgraded the firmware when you added the
KXB3080? If so, the menu entries are set to default, and that means it
is set to ATU CAL - check the menu.
73,
Don W3FPR
KD0FIN wrote:
> So I just installed the KXB3080 and completed the 2 resistor "power mod" but
> now my ATU doesn't seem to be working. It gives me power and SWR reading
> when I use the "tune" function but I don't hear the relays clicking and it
> isn't matching anything anymore. It might be unrelated but also it seems to
> be very hard to find signals as well. I could hear a couple faint ones on
> 80m but everything else seemed dead. The radio was working as normally as I
> could tell after installing the KXB3080, and I don't think I could have
> screwed up the the 2 resistors enough to cause any problems?
>
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.709 / Virus Database: 270.14.103/2558 - Release Date: 12/11/09 05:06:00
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html