Posted by
Ron D'Eau Claire-2 on
Mar 02, 2007; 5:11pm
URL: http://elecraft.85.s1.nabble.com/Vetical-Antennas-tp444325p444337.html
Another source of radiation-causing common-mode currents is an *unbalanced*
two-wire feeder, such as when ladder, window or twinlead is used to feed an
off-center fed dipole.
A balun at the transmitter will do little or nothing to improve the balance.
It's caused by the unbalanced load at the antenna.
That radiation is not always bad if the system is designed to make use of
it. The version of the Windom that uses open wire or twinlead feeders is a
good example (the original Windom used a single wire feeder). In this case
the considerable radiation from the feeder is part of the effectiveness of
the antenna, adding a fair bit of vertical radiation (if the feed line runs
vertically).
The challenge is to recognize that the "feeder" in such antenna systems is
actually part of the radiating antenna and must be run in the clear. It can
be a source of severe RFI if it's run where it can induce heavy RF currents
into nearby conductors, such as TV antenna leads, house power wiring, etc.
Even though a two-wire line might be used, when it's unbalanced it has to be
treated with the same consideration one would give to running a simple
end-fed wire into the shack.
An that's why coaxial lines are so popular in spite of the need to hold down
the SWR to avoid excessive losses.
Ron AC7AC
-----Original Message-----
I agree with Kieth wholeheartedly. SWR on the feedline does NOT cause
feedline radiation - ever.
The thing that causes feedline radiation is common mode currents - most
commonly observed as current flowing on the outside of a coax line. Properly
placed current baluns can eliminate common mode current, but should not
change the SWR,
73,
Don W3FPR
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com