Re: Improvement changes to K2 and K1 transceivers
Posted by
I7SWX on
May 09, 2007; 2:58pm
URL: http://elecraft.85.s1.nabble.com/Improvement-changes-to-K2-and-K1-transceivers-tp447177p447180.html
Hi Bill and Geoff,
thanks for your comments.
I am sorry I replied through the elecraft newsgroup.
73
Gian
I7SWX
--- Geoffrey Mackenzie-Kennedy
<
[hidden email]> wrote:
> Bill,
>
> Gian might be suggesting the use of H-mode mixers to
> replace the TUF-1 mixer
> and NE602 product detector, but I have not asked
> him. The H-mode mixer has a
> much higher 3rd Order Intercept than either the
> TUF-1 or NE602, but I would
> have thought that the very good IMD performance of
> the H-mode mixer would be
> wasted in the K2. As I see it the IMD performance of
> the 2N5109 post mixer
> amplifier, variable bandwidth IF filter and MC1350
> IF amplifier (and
> probably the front end bandpass filters) would
> become the weak link, and
> determine the overall IMD performance of a modified
> K2. Also the H-mode
> mixer requires a 50% duty cycle squarewave LO
> injection for best IMD
> performance which would require some modification of
> the K2's LO and BFO
> output circuitry, although this modification might
> not be necessary because
> of the poor (by comparison) IMD performance of the
> weak link mentioned
> above.
>
> 73,
> Geoff
> GM4ESD
>
>
> On Wednesday, May 09, 2007 at 2:46 AM, Bill Coleman
> wrote:
>
>
> On May 8, 2007, at 11:11 AM, Giancarlo Moda wrote:
>
> > See for file: I7SWX possible changes to K2 and K1
> > RTX. It is possible you need to be a member.
> >
> > The documentation reports suggested changes:
> >
> > 1)Front-end mixer replacement and roofing filter
> > addition. These mods have been implemented and
> tested
> > by I0CG in his K2.
>
> Part of the beauty of the K2 is that it is a very
> simple radio,
> superbly executed. (To paraphrase a comment K9AY
> said to me before I
> bought one)
>
> The K2 uses a TUF-1 balanced mixer with close
> attention to the
> injection levels and impedance matching. You'd be
> hard-pressed to
> improve the mixer performance for HF.
>
> Since the K2 is single-conversion, the primary
> crystal filter IS the
> roofing filter. The primary crystal filter is pretty
> darn good for CW
> or RTTY.
>
> > 2)Demodulator replacement.
>
> What would you do to replace the product detector?
> Since the dynamic
> range of the signals after the AGC of the IF stage
> is pretty limited,
> the NE602 is a pretty good choice. It wouldn't be
> easy to do better,
> especially at the price point for the K2.
>
>
>
>
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com