Posted by
John, KI6WX on
May 15, 2007; 1:57am
URL: http://elecraft.85.s1.nabble.com/K3-roofing-filter-group-delay-tp447425p447429.html
You can cascade a pair of Bessel filters to get better frequency response
while maintaining a flat group delay, but you do have to isolate them so
that they both are seeing a resistive source and load impedance. The
cascaded filters would show a 6 dB rolloff at nominal cutoff frequency. The
3 dB point will occur at about 70% of bandwidth. A pair of 5-pole Bessel
filters cascaded with a 500 Hz 3 dB bandwidth will be down about 55 dB at 1
kHz.
The better method is to build a 10-pole 500-Hz Bessel filter which will be
down nearly 60 dB at 1 kHz.
There was also a question about a linear phase filter with equiripple error.
A 0.5 degree error is about +/-5% variation in group delay. A 5-pole 500-Hz
0.5 degree equiripple filter will be down 50 dB at 1 kHz and have about 11
ms of group delay.
-John
KI6WX
>> Don't forget Bessel filters. These are maximally flat for group delay,
>> but
>> have a much slower rolloff.
>
> John,
>
> What penalty (if any) would occur in cascading identical Bessel filters to
> improve roll-off and stop-band attenuation?
>
> Would the overall response still be considered Bessel, or will a point be
> reached where the response begins to take on Chebyshev characteristics?
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com