Posted by
Don Wilhelm-4 on
Sep 23, 2007; 5:15am
URL: http://elecraft.85.s1.nabble.com/KPA100-KAT100-trouble-tp453506p453507.html
Chris,
As your first step, you need to obtain some 1N5711 diodes - obtain 5 of
them if you have to order any.
First remove the KPA100 and check the base K2 into a good dummy load.
Do you have good power control over the entire range? If yes, the base
K2 is working, but if no, replace RF Board D9 and re-check.
Once you have verified that the base K2 can control the power output,
add the KPA100 - operate into a dummy load (no antennas please because
there are too many variables to deal with). If the K2 with KPA100
properly controls power and displays a 1:1 SWR, then you will have 2
more extra diodes. OTOH, if the KPA100 produces full power output no
matter where the power knob is set, then replace D16 and D17 in the
KPA100. The K2 with KPA100 should now properly control power output.
Lastly, add the KAT100, but set the ATU menu to CAL and connect the
dummy load to the KAT100. If all works well, you have extra diodes, but
if all is not well, then replace D1 and D2 in the KAT100.
After all is working fine into a dummy load, then you can connect an
antenna and try it out - you should find normal behavior.
OK, this has been simplistic and considers only that the lightning
zapped the wattmeter diodes. This is usually the only consequence, but
if at any point, normal behavior is not restored after replacing the
diodes, there is some other problem that must be investigated before
attempting to proceed any further with the testing.
73,
Don W3FPR
Chris Kantarjiev wrote:
> I may be having my first run-in with lightning damage.
>
> A thunderstorm rolled through the SF Bay Area last night. I didn't
> disconnect my antennas until I *saw* the first lightning flash.
>
> Oops, I think.
>
> I turned on the radio later in the evening, and was getting very
> high SWR indications on the KAT100, and HiCur on the K2. Hitting
> TUNE caused a lot of clicking and clacking, and eventual tune to
> about 1.5:1, but SWR was still high on transmit - and the indicated
> power on the bargraph was lower than dialed in. This is on both
> antennas - a vertical and OCF dipole - both more or less resonant.
>
> I turned off the rig and called it a night.
>
> This morning I pulled out my LP200 dummy load/power meter. The ATU
> tunes it to 1.1:1. Power out does not change appreciably
> in response to the POWER knob - if set for any value less than 10W,
> the power is about 4W; if set for values about 10W (PA on), power
> out is always about 30W. In neither case is the LED indication on
> the K2 correct.
>
> I also notice that the SWR LEDs no longer display anything when the
> power is set below 10W, but indicate as expected when POWER is
> above 10W.
>
>
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com