Posted by
PHIL-14 on
May 28, 2010; 8:15pm
URL: http://elecraft.85.s1.nabble.com/ELECRAFT-TO-TOKYO-HY-POWER-2-5-tp5113595p5114540.html
OK - Here is my problem, I should have worded it different. I bought an "open box" Linear and it came without any cables. So I guess I need to know what pins go to what pins.....I can get the connectors and build my own cable if I know what hooks where...I replaced the board in my K3 so I didn't have to do the pull-up resistor thing when I first hooked up the 1.5 unit
PHIL. www.n2bee.net
"Sometimes I think I understand everything, then I regain consciousness"
----- Original Message -----
From: Phil & Debbie Salas
To:
[hidden email]
Sent: Friday, May 28, 2010 11:55 AM
Subject: Re: [Elecraft] ELECRAFT TO TOKYO HY-POWER 2.5
The THP2.5 uses a regular 15-pin D-connector, whereas the K3 uses the 15-pin
HD D-connector. Nothing special needs to be done, other than finding the
pin outs from the manuals. The THP 2.5 even has pull-up resistors so early
K3 radios will drive the band data input just fine (NOT the case with the
THP 1.5, where you need the K3 pull-up mod). If you plan on using ALC, you
do need the K3 negative-going ALC mod if you have an early K3.
Phil - AD5X
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/mmfaq.htm Post: mailto:
[hidden email]
This list hosted by:
http://www.qsl.net Please help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html