http://elecraft.85.s1.nabble.com/ELECRAFT-TO-TOKYO-HY-POWER-2-5-tp5113595p5114730.html
Authorized Service Center (but then ... )
... Joe, W4TV
> OK - Here is my problem, I should have worded it different. I bought
> an "open box" Linear and it came without any cables. So I guess I
> need to know what pins go to what pins.....I can get the connectors
> and build my own cable if I know what hooks where...I replaced the
> board in my K3 so I didn't have to do the pull-up resistor thing when
> I first hooked up the 1.5 unit PHIL. www.n2bee.net "Sometimes I
> think I understand everything, then I regain consciousness" -----
> Original Message ----- From: Phil& Debbie Salas To:
>
[hidden email] Sent: Friday, May 28, 2010 11:55 AM Subject:
> Re: [Elecraft] ELECRAFT TO TOKYO HY-POWER 2.5
>
>
> The THP2.5 uses a regular 15-pin D-connector, whereas the K3 uses the
> 15-pin HD D-connector. Nothing special needs to be done, other than
> finding the pin outs from the manuals. The THP 2.5 even has pull-up
> resistors so early K3 radios will drive the band data input just fine
> (NOT the case with the THP 1.5, where you need the K3 pull-up mod).
> If you plan on using ALC, you do need the K3 negative-going ALC mod
> if you have an early K3.
>
> Phil - AD5X
>
> ______________________________________________________________
> Elecraft mailing list Home:
>
http://mailman.qth.net/mailman/listinfo/elecraft Help:
>
http://mailman.qth.net/mmfaq.htm Post:
> mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net Please help support this
> email list:
http://www.qsl.net/donate.html> ______________________________________________________________
> Elecraft mailing list Home:
>
http://mailman.qth.net/mailman/listinfo/elecraft Help:
>
http://mailman.qth.net/mmfaq.htm Post:
> mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net Please help support this
> email list:
http://www.qsl.net/donate.html>