Posted by
Bill K9YEQ on
May 28, 2010; 10:14pm
URL: http://elecraft.85.s1.nabble.com/ELECRAFT-TO-TOKYO-HY-POWER-2-5-tp5113595p5114864.html
Mine works just fine without ALC. I Don't believe the anti-liability stuff
with ALC connections from amp producers. If you have your K3 using ALC and
provide a consistent output to your amp then it isn't an issue. If you try
to run over the 1.5kw limit for Amateur operation, it is an issue.
Bill
K9YEQ
K2 and KX1 field tester, K3 and modules
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]] On Behalf Of Howard K2HK
Sent: Friday, May 28, 2010 11:05 AM
To:
[hidden email]
Subject: Re: [Elecraft] ELECRAFT TO TOKYO HY-POWER 2.5
I use similar arrangement. I follow K3 recommendation of no ALC which is
contrary to advice I received from THP. When using THP parameters I had
problems. Been ALC free 1yr plus.
Howard..K2HK
> From:
[hidden email]
> To:
[hidden email]
> Date: Fri, 28 May 2010 10:55:54 -0500
> Subject: Re: [Elecraft] ELECRAFT TO TOKYO HY-POWER 2.5
>
> The THP2.5 uses a regular 15-pin D-connector, whereas the K3 uses the
15-pin
> HD D-connector. Nothing special needs to be done, other than finding the
> pin outs from the manuals. The THP 2.5 even has pull-up resistors so
early
> K3 radios will drive the band data input just fine (NOT the case with the
> THP 1.5, where you need the K3 pull-up mod). If you plan on using ALC,
you
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html