P3 MKR off freq?

Posted by Gary Ferdinand on Sep 23, 2010; 4:33pm
URL: http://elecraft.85.s1.nabble.com/P3-MKR-off-freq-tp5563760.html

I'm sure this is "user error," but so far this user fails to figure it out.
This started happening right around the time I loaded the current firmware
into both the K3 and the P3.  When I tune or recall a memory in the K3, the
P3 correctly displays the frequency and it appears to be centered within the
brackets on the smallest scan.  However, when I use either marker and line
it up with a signal off the current K3 frequency and tap select on the P3,
the end result on the K3 is off about a KHz and this also shows up on the P3
- ie the signal I thought I put the marker on is now showing up down from
current frequency.

Any ideas?  Yes, I have calibrated the P3 according to the instructions on
p19 of the manual, and the transceiver settings are unchanged and specify
K3.

Thanks in advance.... Gary W2CS


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html