Posted by
Bill K9YEQ on
Sep 23, 2010; 5:42pm
URL: http://elecraft.85.s1.nabble.com/P3-MKR-off-freq-tp5563760p5564035.html
Check your shift frequency. I had the same issue and it took me a bit to
figure it out. Once the NORM button was held in, voila, fixed! There are
other offsets I am sure which could also change the center freq, but my
solution is the simple easy one.
Bill
K9YEQ
-----Original Message-----
From:
[hidden email]
[mailto:
[hidden email]] On Behalf Of Gary Ferdinand
Sent: Thursday, September 23, 2010 11:33 AM
To: Elecraft
Subject: [Elecraft] P3 MKR off freq?
I'm sure this is "user error," but so far this user fails to figure it out.
This started happening right around the time I loaded the current firmware
into both the K3 and the P3. When I tune or recall a memory in the K3, the
P3 correctly displays the frequency and it appears to be centered within the
brackets on the smallest scan. However, when I use either marker and line
it up with a signal off the current K3 frequency and tap select on the P3,
the end result on the K3 is off about a KHz and this also shows up on the P3
- ie the signal I thought I put the marker on is now showing up down from
current frequency.
Any ideas? Yes, I have calibrated the P3 according to the instructions on
p19 of the manual, and the transceiver settings are unchanged and specify
K3.
Thanks in advance.... Gary W2CS
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html