Re: APF For K3

Posted by GW0ETF on Oct 24, 2010; 8:48pm
URL: http://elecraft.85.s1.nabble.com/APF-For-K3-tp5671688p5668627.html

Be aware though that the DSP 'switches off' the EQ once you get to 100Hz and below bandwidth. If you raise your cw sidetone frequency band as you suggest and then wind down the bandwidth your signal will take a dive as you cross the 100Hz point.

73,

Stewart Rolfe, GW0ETF

 

N8XPQ wrote

I have found that using the receive EQ for this works quite nicely. I raise the frequency matching that of my side-tone and attenuate all others. The K3 will automatically switch to this EQ setting when you enable the CW mode and switch to the SSB setting when that mode is enabled.

Good luck,

Mike N8XPQ