at 12W then pushing the low power PA. OTOH, which would give the cleanest
> And if you care about transmitting the cleanest signal, you'll hold the
> K3/10 output to 10 watts PEP. Squeezing higher power out degrades the IMD.
> The Power control provides some additional room to be sure everyone can
> make
> the rated 10 watts.
>
> The same is true for the K2/10.
>
> Ron AC7AC
>
> -----Original Message-----
> Well, let's see if I can do this right: 15 db = 10 log (Pout / 12 watts)
>
> where 15db is the FCC maximum allowed gain. Assuming that 12 watts
> will drive the KPA500, we solve for Pout as: 12 watts * 10^1.5 = 379
> watts
>
> So, if I did the calculation correctly, that would be legal maximum. I
> would suspect the gain to be less, perhaps in the 200-300 watt range
> for no other reason than it feels right to my mind. There may also
> have been an email from Lyle that mentioned something in the 200 watt
> range, but I'm not sure.
>
> 73, Byron N6NUL
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>