http://elecraft.85.s1.nabble.com/KPA-500-from-Orlando-tp6024743p6029832.html
per-band sink and source outputs to drive antenna relays, etc. It can
> Wayne -
>
> Can the K3 drive a band decoder (aka automagic antenna sw) and the
> KPA500
> simultaneously via the 15 pin connector?
>
> 73, Mike NF4L
>
> On 2/15/2011 4:05 PM, Wayne Burdick wrote:
>>> Jack, doesn't the k3 have a way of automatically setting the band on
>>> the KPA500?
>> Yes. It can do this in two ways: (a) RF sensing; (b) band data from
>> the K3.
>>
>> The K3 can be connected to the KPA500 via the 15-pin connector. This
>> will provide band data for the amp when the K3's band is changed. But
>> it will also allow you to use the amp's band switches to change bands
>> on the radio, see a report of amp fault conditions, operate/standby
>> status, etc.
>>
>> The nice thing about having the K3 know about amp operate/standby
>> status is that the K3 can provide two entirely different per-band
>> power-level setups. When you put the amp into operate condition, it
>> will retrieve all of the amp drive levels you set up on each band.
>> When you go to standby, the K3 will use its "barefoot" power
>> settings.
>>
>> Some of this is still being tested and has not been provided to field
>> testers yet.
>>
>> 73,
>> Wayne
>> N6KR
>>
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home:
http://mailman.qth.net/mailman/listinfo/elecraft>> Help:
http://mailman.qth.net/mmfaq.htm>> Post: mailto:
[hidden email]
>>
>> This list hosted by:
http://www.qsl.net>> Please help support this email list:
http://www.qsl.net/donate.html>>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html