http://elecraft.85.s1.nabble.com/KX1-Red-Display-Filter-tp6249633p6249652.html
I used two thin strips of duct tape. The tape supplied with my kit did not hold either.
> From: Chuck Guenther <
[hidden email]>
> Subject: [Elecraft] KX1 Red Display Filter
> To:
[hidden email]
> Date: Thursday, April 7, 2011, 7:49 AM
> Instructions for installing the LED
> filter are given on page 52
> of the latest KX1 manual (Rev. E, dated May 21, 2010).
>
> The transparent tape just didn't hold in my case, with the
> result
> that the filter is floating around inside the case
> somewhere, leaving
> the LED display chip exposed.
>
> Has anyone discovered a better way to attach this
> filter? I'm thinking
> of using a very small quantity of RTV sealant, judiciously
> applied
> around the edges of the filter with a toothpick. Any
> thoughts?
>
> Thanks & 73,
>
> Chuck Guenther NI0C
> KX1 s/n 2512
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>