Posted by
Don Wilhelm-4 on
May 03, 2011; 5:32pm
URL: http://elecraft.85.s1.nabble.com/K2-Alignment-with-Spectrogram-tp6327964p6328135.html
Jim,
You may be picking up noise on your soundcard input cable.
The only thing you really need to see are the skirts of the passband (so
you can discern the center for CW and the proper placement of the low
frequency skirt close to 300 Hz for the SSB filters) - most everything
else can be ignored for the purpose of aligning the filters. In other
words, you are not analyzing all aspects of the audio signal, just
determining where the passband is. You should have only noise coming
into the K2. If there is a signal present, it will only confuse the
display and make things more difficult.
For the L34 adjustment, tune to the birdie at 7000 kHz - turn the preamp
on so it is more pronounced.
Use something close to a 700 Hz wide filter. Then first adjust L34 so
the signal spike goes up as far as possible - then tune around that
point (about a turn either direction) while observing the high frequency
end of the audio spectral display to see if you can reduce the noise
level there without reducing the height of the signal spike. If you do
not observe any difference, leave L34 set at the peak for the spike.
That is all there is to it.
73,
Don W3FPR
On 5/3/2011 12:39 PM, Jim Faulkner wrote:
> My K2 S/N 5149 has been up and running well for about 5 years. I finally
> decided to check out the filter alignment using Spectrogram. I
> downloaded v.16, and am running it through Wine since I'm using Ubuntu
> as an operating system. I couldn't get the version on Tom's page to run
> this way, and right now, I don't have easy access to a Windows machine.
>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html