Login  Register

KX1 - S/N 2543 Received and ready for build

Posted by Ken Race on Jun 15, 2011; 8:41pm
URL: http://elecraft.85.s1.nabble.com/KX1-S-N-2543-Received-and-ready-for-build-tp6480496.html

>From Hamvention, I ordered the KX1 with the ATU, the paddles and the 3080
mod kit.  They arrived a couple of weeks ago.  This is going to start a line
of firsts for me: first major kit, first time learning CW (in a serious
fashion), first time into qrp, etc.  I'm excited to start, but a bit
intimidated at the same time.  However, I have a need for some advice as I
go forward.

 

I've started the parts inventory and, when I got to the 3080 mod kit, I also
found the power output mod kit.  My question is: can I install the power
output mod while I am building the KX1 basic radio since it replaces only
two resistors?  Or, should I wait until after the KX1 is assembled?  Does it
change any of the checkout readings?

 

A number of years ago, I bought a XYtronics soldering station.  I've had
some minor difficulties getting replacement tips for the iron.  I ordered
and received several different sizes, but I'm not sure any are optimum for
this kit.  I have a 1/16" chisel, a 1/64" conical, and a 1/32" conical tip.
They apparently have a 1/32" semi-chisel, but I haven't found one anywhere
yet.  Is it possible to grind a small chisel surface on the 1/64" conical
tip?  Does this cause any issues with the tip or with the soldering
operation?  Is the 1/16" chisel small enough to do this kit?

 

One more inventory to finish, then on to soldering...

 

Thanks in advance for your help.

 

Ken Race - AB8GQ

 

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html