Re: KPA500 Assembly Question

Posted by Jim Bennett on
URL: http://elecraft.85.s1.nabble.com/KPA500-Assembly-Question-tp7080004p7080387.html

Sorry about this, guys - this post went out days and days ago - why it is just now showing up is beyond me.. AND, the problem is fixed.

On   Saturday, Dec 3, 2011, at  Saturday, 1:31 AM, Jim Bennett wrote:

> I Just started assembling my KPA500 serial number 0585 this evening. All was going OK until I got to the point where I mount the Z-bracket to the PA/LPF heat sink. The book sez to use 4-40 5/16" black flat head screws. Using this size screw does NOT pull the Z-bracket tight against the heat sink. I've measured these screws three times and I am certain I'm using 5/16" screws. If I use a 3/16" screw, it works fine. Also, I have verified that I've positioned the PA/LPF properly. So, is the documentation wrong, or is this Z-bracket supposed to be wobbly and not tight against the heat sink?
>
> Thanks, Jim / W6JHB
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html