Re: K1: noise blanker instructions theory

Posted by Don Wilhelm-4 on Dec 17, 2011; 10:29pm
URL: http://elecraft.85.s1.nabble.com/K1-noise-blanker-instructions-theory-tp7104624p7104824.html

Stephen,

Is there a place for C12 and C13 on the top of the board? If not, place
them on the bottom as shown in the instructions for the Rev C board.

73,
Don W3FPR

On 12/17/2011 3:02 PM, Stephen Prior wrote:

> This is reposted, since I never saw it appear on the list, apologies if it's
> a dupe.
>
> AnywayŠŠŠŠ..
>
>
> I'm just about to build the K1 noise blanker to take my mind off the KX3!
>
> In the errata sheet, I am confused by the change to the bottom of page 5:
> 'If your board is revision C, solder .........'
>
> I have looked at the print on the pcb and it says Rev. Cr
>
> Is that revsion C or not I wonder?  I know it's not A or C, but to my mind
> Cr does not equal C!
>
> Thanks
>
> Stephen G4SJP
>
> PS.  To UK readers of this, I ordered the kit from QRP project in Germany
> and paid less than I would have done direct from Elecraft once the shipping
> was taken into consideration.
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html