Re: XG3 output above 200-MHz

Posted by Alan Bloom on Jan 03, 2012; 5:25pm
URL: http://elecraft.85.s1.nabble.com/XG3-output-above-200-MHz-tp7146019p7147492.html

Since the output is a square wave, I assume they are using only odd
harmonics.  Probably the fundamental is 222.2 / 3 = 74.07 MHz.

Theoretically, the harmonics are inversely proportional to the harmonic
number.  So the third harmonic should be 20 * log (1/3) = -9.54 dB.
However it might be weaker than that, especially on the higher
frequencies, depending on the circuitry.

I would measure mine, but my spectrum analyzer is currently on loan.

Alan N1AL


On Mon, 2012-01-02 at 23:23 -0900, Edward R. Cole wrote:

> I finished building my 222-28 transverter and decided to test the Rx
> using the XG3 on 222.200 MHz.  I am not seeing a very strong signal
> (had to use the -73 dBm level) so questioning if my transceiver
> sensitivity is off.
>
> I understand that the output of the XG3 is calibrated up to 200-MHz
> and above that harmonics are used (up to 1420 MHz).  I would assume
> then when I entered a freq = 222.200 that the XG3 is really running
> at 111.100 + harmonics.  I wonder if one can use the rule of 1/n for
> predicting the nth harmonic output level?  Been too long since I
> studied Fourier series to remember the coefficients for a square wave.
>
> I measured the XG3 output on my HP432A microwave power meter (10-MHz
> - 18GHz) which can read from -20 to +10 dBm.  I see an output of -3
> dBm when running either 222.200 or 144.200 MHz.  I am assuming I am
> measuring the total harmonic energy since I have no filters in use.
>
> I wonder if Elecraft might have done an output curve for the 0 dBm
> output for the whole operating freq. range?  I am also assuming the
> XG3 attenuators for -33, -73, and -107 dBm are wideband over the full
> operating range.
>
> I don't have a spectrum analyzer to measure power lower than -20 dBm.
>
>
> 73, Ed - KL7UW, WD2XSH/45
> ======================================
> BP40IQ   500 KHz - 10-GHz   www.kl7uw.com
> EME: 50-1.1kw?, 144-1.4kw, 432-QRT, 1296-?, 3400-?
> DUBUS Magazine USA Rep [hidden email]
> ======================================
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html