http://elecraft.85.s1.nabble.com/P3-w-SVGA-No-actual-RF-Frequency-display-tp7394246p7394260.html
lack of power. I'd power the P3 from another source with a temporary
cord, if you can, while you await arrival of the one from Elecraft.
> Got the P3/SVGA today. It was an assembled unit with the SVGA factory
> installed. I am powering it off the K3 +12 volt output. The new power cable
> is in the mail. It has not shut down after all afternoon and evening ON.
>
> It has never displayed the actual RF frequency up in the center top of the
> screen or at the left or right side top. Zero is at the top center and the
> +/- Spans are at the ends. I can adjust the span as it describes. The
> Markers only display the offset from the center, not the RF frequency.
>
> I cannot toggle it to the Fixed Mode also. It stays in the Tracking Mode. I
> have the latest firmware installed (P3 1.12, K3 MCU 4.39, FPF 1.14, DSP1
> 2.73). The cables between the P3 and the K3 are per the manual. I even
> tried a reload of the K3 and P3 firmware and even reinitialized the P3 (page
> 28 of the manual).
>
> I am using an external 19 inch flat panel Acer monitor. Any ideas what I am
> doing wrong?
>
> Roger W5RDW
>
>
>
> -----
> Roger W5RDW
> --
> View this message in context:
http://elecraft.365791.n2.nabble.com/P3-w-SVGA-No-actual-RF-Frequency-display-tp7394246p7394246.html> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html