Login  Register

Re: wiring the KX1 paddle

Posted by Don Wilhelm-4 on May 04, 2012; 7:46pm
URL: http://elecraft.85.s1.nabble.com/wiring-the-KX1-paddle-tp7528281p7528479.html

Joe,

I have done many of them, and while soldering "down in the hole" to the
connector pin is a bit of a challenge, I have not found a better way.  
Do not try to put the wire through the hole in the lug, it is adequate
to dress it along the side of the lug (make sure it is touching) and
solder with a slender tip.

73,
Don W3FPR

On 5/4/2012 2:56 PM, [hidden email] wrote:

> I just finished assembling my first KX1 paddle. Wiring the paddle boards to
> the installed 3.5mm phone plug was challenging to say the least. Has anyone
> figured any practices to make this easier? I think there may be a second KX1
> in ,my future and I want to be prepared.
> Thanks.
> Joe
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/wiring-the-KX1-paddle-tp7528281.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html