Posted by
Gary Hinson on
Jun 10, 2012; 2:00am
URL: http://elecraft.85.s1.nabble.com/K1-no-power-out-B2-tp7557347p7557396.html
Hi Kent.
It could be an RFI issue but it could also be a faulty connection somewhere
that won't pass enough current for high power.
Do the KPS's SWR LEDs light up like a Christmas tree when you operate
barefoot at about 100W with the KPA in standby? If so, you clearly have a
problem with your antenna or feed.
With the KPA in operate mode, watch those SWR LEDs as you gradually increase
the drive from 5 to 25W: if it seems OK at the low end but suddenly flashes
the oranges/reds and faults out, I'd suspect a dodgy connector, most likely
one outside that has corroded or loosened.
73
Gary ZL2iFB
K2 K3 KPA500 W2 Mojo
PS You can search the archives for lots more through Nabble e.g.
http://elecraft.365791.n2.nabble.com/template/NamlServlet.jtp?macro=search_page&node=365791&query=kpa+swr
> -----Original Message-----
> From:
[hidden email] [mailto:elecraft-
>
[hidden email]] On Behalf Of Kent Tiburski
> Sent: Sunday, 10 June 2012 1:33 p.m.
> To:
[hidden email]
> Subject: [Elecraft] KPA500 Issues
>
> Hi,
>
> I have a KPA500 amp and have some issues with it. I ran on my Cushraft
R-8
> vertical with fault (SWR) problems. I went to use it on the VHF contest
with
> my meager 3 element yagi and it faults out? Hunhh? Checked the VSWR
> with a meter and my antenna analyzer and it shows a 1.2 to 1 ratio. OK I
> thought there was feedback so I put a bunch of ferrite cores and even
> wrapped 8 turns on the coax (balun) to no avail. What gives? This was
mainly
> on 6 meters but to some extent on other bands also. Checked VSWR with a
> meter on radio (FLEX 5000A). I think it's in KPA500 circuit. Any ideas?
I'm a
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html