KPA500 not reading Band Data
Posted by
w0uo on
Jul 14, 2012; 12:20am
URL: http://elecraft.85.s1.nabble.com/KPA500-not-reading-Band-Data-tp7559077.html
Elecrafters:
I just installed a "Y" cable from my K-3 to an Array Solutions DBS-1 band
decoder and my KPA 500. The band decoder follows the K-3 perfectly, but the
K-3 doesn't read band data. It does tell the K-3 when it is on standby and
operate and the K-3 sets the power level accordingly. From this I assume
that it is not reading the four band data pins (when powered up it reads 5.3
MHz, all logic zeroes, and does not change until it senses RF).
Has anyone had the same or similar problem and found a solution?
Jim Spaulding W0UO
[hidden email]
817 448 8024 (home)
817 713 9928 (cell)
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html