Posted by
Joe Subich, W4TV-4 on
Apr 16, 2013; 2:56pm
URL: http://elecraft.85.s1.nabble.com/Cancel-XG3-morse-tx-tp7572629p7572671.html
Depends on the version ... some pots are mounted vertically,
some flat, some have holes in the board to adjust through, etc.
My preference is the RS-35A ... the non-metered version. I find the
metering not that accurate. Since the supplies are mounted below
the bench and I usually get the DVM when setting them up, I don't
see a justification for the added expense <G>.
73,
... Joe, W4TV
On 4/16/2013 10:37 AM, Richard Fjeld wrote:
> I haven't pulled the cover on my RS-35M yet. Does it have adequate clearance to get to the pot, or did you have to improvise?
>
> Rich, n0ce
>
> ----- Original Message -----
> From: Mike Reublin
> To: Tom Branton
> Cc:
[hidden email]
> Sent: Tuesday, April 16, 2013 9:05 AM
> Subject: Re: [Elecraft] K3 power supply recommendations
>
>
> I've used an Astron RS-35M very happily for years. Had to turn it up a tad for the K3.
>
> Tip: The voltage adjustment is on the under side of the board......
>
> 73, Mike NF4L
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html