Login  Register

Re: K2 Won't power on

Posted by JeremyJones on Feb 12, 2014; 1:58pm
URL: http://elecraft.85.s1.nabble.com/K2-Won-t-power-on-tp7584083p7584107.html

With Q7/Q8 removed, the resistance from the Collector solder pad to ground on both is 70 ohms.

Doing a "Tune" with Q7/Q8 removed results in 1.0V on the Base pads and a Low P on the display.  I do have the KAT2 installed, just in case this makes a difference.  This was done into a dummy load.

The antenna that I normally run is an 80m Carolina Windom strung up between a tree in my front yard to a tree in my backyard.  I have no additional grounding to it, just the baluns that are part of the normal antenna design.  I am very cautious of lightning in the summer, and leave the antennas disconnected when not using the radio, however given that its winter here and sub zero temperatures, I didn't worry about it.  I had never heard of static caused by the wind.  What is a good way to protect against this?

Thanks,
Jeremy
VA3ZTF