LCD and error codes
Posted by k7btw on Jan 22, 2015; 9:10pm
URL: http://elecraft.85.s1.nabble.com/LCD-and-error-codes-tp7597382.html
I'm up to page 36 in the K1 manual, Alignment and Test, Part 1. All resistance and voltage checks fine up to this point. When power turned on, I do not get the E27 error code. The LCD is blank, except for a few vertical bars on the top half of the display. If I press a switch, they go away and the LCD is blank. I've done all the usual kinds of inspections, including going back over the instructions step by step. I could use some suggestions. Thanks.