Login  Register

Re: Grounding question on remote tuner

Posted by Barry K3NDM on Apr 05, 2017; 6:54pm
URL: http://elecraft.85.s1.nabble.com/Grounding-question-on-remote-tuner-tp7629022p7629023.html

Randy,
     I would definitely ground the remote tuner. I infer that you are
feeding the  inverted L at the base and working it against ground. In
this circumstance, the antenna tuner is a part of the system and should
be grounded to the remainder of your ground system. Think of it this
way. Your tuner in in series between the inverted L and your ground
which represents the other half of your antenna system.

     I'm not sure I would use an 4:1 unum as you are. I would put an
isolator between the tuner and the run to your shack. You will be
feeding the antenna through the tuner which needs to see both the ground
half of your antenna system and the antenna itself. The unum will
attempt to isolate parts of the system that should not be isolated.
However, you do need to keep RF off the transmission line going to the
shack and an isolator will accomplish this.

73,
Barry
K3NDM

------ Original Message ------
From: "Randy Cook" <[hidden email]>
To: [hidden email]
Sent: 4/5/2017 2:19:30 PM
Subject: [Elecraft] Grounding question on remote tuner

>Weather damage repair time. I am rewiring my ~84 foot inverted L
>antenna system, Up a SpiderPole about 31 feet, out about 53 additional
>feet. Still tuning length.
>I have mounted a remote MFJ tuner on a post about 3 feet from the
>antenna base. Antenna wire goes down the pole, connects to 4:1 Unun
>input lug, then goes via coax to tuner. Out of the tuner to a long coax
>run to my shack. Choke at the rig end of the coax run.
>Radials mount on ground connection lug on the Unun.
>I was a bit confused with the tuner wiring. The manual says to connect
>ground lug to the ‘system ground’, I assume that means the radial
>collection point. But, isn’t the tuner already connected to the ‘system
>ground’ via the coax shield? Is it necessary to run another wire from
>the tuner ground to the radial connection ground?
>
>Thanks in advance for any advice.
>
>73
>Randy - K6CRC
>
>
>
>
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:[hidden email]
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to [hidden email]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]