Login  Register

Re: Low power out, ERR TXG when trying to calibrate power

Posted by Don Wilhelm on Apr 18, 2017; 12:04pm
URL: http://elecraft.85.s1.nabble.com/Low-power-out-ERR-TXG-when-trying-to-calibrate-power-tp7629471p7629474.html

Rob,

I would try running the TX Gain Calibration with a higher voltage power
source - at least 13.8 volts.

If it still fails, contact Elecraft support.

73,
Don W3FPR

On 4/18/2017 5:55 AM, M0VFC wrote:

> Hi folks,
>
> My KX3 seems to have developed a low output power problem.
>
> All used to be fine, but over the weekend I noticed it now only gives ~6W
> maximum on CW despite a good SWR indication. I have reproduced this into a
> dummy load (1.1:1 SWR) and checked DC input voltage (11.2V key down,
> external 3S LiPo).
>
> Additionally, if I engage the ATU, it no longer seems able to find a good
> match, even into a dummy load. Bypassing the ATU results in an indicated
> 1.1:1 SWR, and removing the ATU module does not fix the low output power
> problem.
>
> If I run the manual TX power calibration (set power to 6W and hold TUNE),
> the VFO B display reaches about 5.4W then stays there. Tapping TX to stop
> the procedure results in ERR TXG being shown. Doing the same at 4W results
> in maximum output power of about 3.2W, from memory, and a similar ERR TXG
> error.
>
> This is true on all HF bands.
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]