http://elecraft.85.s1.nabble.com/KX-1-antenna-matching-tp7631522p7631526.html
from. Also, my counterpoises have not always been on the earth;
some "extensions" like you described and do some testing tomorrow. I
also like your idea about clipping it to a metal picnic table. Today, I
table on my rear deck. Never thought about trying that! I've got a
RFI. Still, might be worth a quick clip-up to see.
> Stan,
> I have used a kx 1 for thousands of QSO’s many in the field on
> 40, 30, and 20 meters. My usual field antenna is a 26 ft piece of
> wire and one or two 17 counterpoise wires. If the counterpoise
> (radial) wires are laying directly on the ground, usually I get a very
> good match on all 3 bands. If part or all of the counterpoise/radial
> wire is elevated, then sometimes I clip on an extension of about 8
> feet to get a better match if the SWR is higher than about 2:1
> (probably only necessary on 40 meters sometimes). Occasionally for 40
> meter elevated counterpoise operation I have even used a single 34 ft
> counterpoise wire if I happen to have one available….not likely when
> backpacking. I would just use your 16 or 17 ft counterpoise for 20
> meters…it might improve your 1.6:1 SWR, however I still have my
> original PA transistor and have often operated with SWR’s around 2:1
> or higher, however my goal is to try not to exceed about 2:1. Usually
> I can get SWR down somewhere between 1:1 and and perhaps 1.9:1 (just a
> guess) on 40 meters, and often about the same or even slightly better
> on 20 and 30 meters. I always carry a 8 ft piece of wire with a big
> clip on the end. Often clipping it to a metal picnic table, guard
> rail, chain link fence, or car body either instead of a radial, or in
> addition to one and get satisfactory performance. If I use an
> elevated counterpoise…then I clip the 8 ft wire onto the end of my 17
> ft counterpoise for better matching on 40 and possibly 30 meters. I
> see no reason to just use a 8 ft counterpoise or radial wire for 20, a
> 16 or 17 wire should be better on all the bands. Occasionally I lay
> down two 17 ft radial wires on the ground if I have them and there is
> room. Some of my attempts at modeling showed slightly improved
> performance. If I have a preferred direction I often lay them down in
> roughly that quadrant. The theory is it may slightly help in that
> direction, but more important it may eliminate a very slight null
> opposite to the desired direction. This is my unproved theory only
> since it would be nearly impossible to measure something like a dB or
> so.
> This is usually the only antenna I carry for backpacking,
> or travel around the US or Europe. Something like a linked dipole
> (usually set up as an inverted V) will often perform significantly
> better, however I much prefer something like the 26 ft wire….5 minutes
> to set up and lots of time to operate vs. an hour set up and less
> operating time.
> Rick KL7CW Palmer, Alaska
> Sent from Mail for Windows 10
>
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]