Re: KX3 with BL2 Question
Posted by
rich hurd WC3T on
Oct 04, 2017; 3:58pm
URL: http://elecraft.85.s1.nabble.com/KX3-with-BL2-Question-tp7634878p7634886.html
Thanks for the feedback.
---
72,
Rich Hurd / WC3T / DMR: 3142737
PA Army MARS, Northampton County RACES, EPA-ARRL Public Information Officer
for Scouting
Latitude: 40.761621 Longitude: -75.288988 (40°45.68' N 75°17.33' W) Grid:
*FN20is*
On Wed, Oct 4, 2017 at 11:50 AM, Don Wilhelm <
[hidden email]> wrote:
> Rich,
>
> It is a common misconception that the characteristic impedance of the
> feedline is what you will have to match. That is only true for resonant
> antennas. The feedpoint impedance of a dipole in free space is 72 ohms,
> but when mounted at practical heights above ground, the feedpoint impedance
> will drop. For most HF antennas, 50 ohms is a better choice.
>
> The other point is - yes, a balun is a good thing. For parallel feedline,
> the balun should be at the junction of the coax and the parallel feedline
> to keep the antenna and feedline currents opposite and equal (the required
> condition for balanced), and to keep common mode current to a minimum.
>
> For non-resonant antennas, the feedpoint impedance of the line at the
> transmitter can vary from very low to very high. It all depends on the
> length of the feedline, the length of the radiator and the frequency.
> In many cases, feeding an antenna with 450 ohm feedline, a 1:1 balun will
> work better than a 4:1 balun.
> You must match the feedpoint impedance, and that is not the characteristic
> impedance of the line.
>
> BTW, zip cord is quite lossy at RF, and should only be used in situations
> where nothing else is available.
> Your example will work, but it is a one band antenna. The main reason for
> using parallel feedline is to be able to use the antenna on multiple bands.
>
> 73,
> Don W3FPR
>
>
> On 10/4/2017 10:35 AM, rich hurd WC3T wrote:
>
>> Would not a bnc-to-banana plug adapter hooked to a doublet made from 100'
>> of zip cord be equally useful? Is there even a reason to have a balun
>> in-circuit? I've read the characteristic impedance of the zip cord (or
>> speaker wire, etc.) is about 75 ohms. If you "unzipped" 67 feet or so and
>> put on a tie wrap (to avoid further unzipping), you'd have a quite
>> serviceable 40 meter dipole with an SWR of 1.5:1 or so.
>>
>>
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]