http://elecraft.85.s1.nabble.com/ATU-TUNE-does-not-work-in-DATA-A-Split-mode-tp3785489p7635985.html
...nr4c. bill
> On Nov 16, 2017, at 3:50 AM, Michael Eberle <
[hidden email]> wrote:
>
> Was this issue ever resolved? I have noticed the same thing with mine
> although the issue does not appear to be the tuner itself, but the K3 is not
> transmitting any power so the tuner has nothing to work with. I am running
> FW version 5.60 an have this issue but only on 6 Meters.
>
> I can power up the K3 and open WSJT-X on my computer and select 6 meters
> which usually causes SPLIT to turn on. Hold TUNE and the TX keys and the
> display shows 0 power. Turn off SPLIT and it puts out power as usual. Then
> if I turn SPLIT back on, it will then output a carrier as usual.
>
> If SPLIT is enabled on 6 meters and you run a TX gain calibration, it will
> fail the calibration because the TX puts out no power.
>
> It's not a major issue but an annoyance since I tend to forget about it
> every time I switch from HF to 6 and try to check my antenna tuning.
>
> Thanks,
> Mike, KI0HA
>
>
>
>
>
> --
> Sent from:
http://elecraft.365791.n2.nabble.com/> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]