Re: K3 SSB +CW Power Overshoot
Posted by
K8TE on
May 28, 2018; 6:42pm
URL: http://elecraft.85.s1.nabble.com/K3-SSB-CW-Power-Overshoot-tp7641319p7641328.html
Dan,
I experienced a similar issue with my K3, S/N range 4,000. I attempted a TX
Gain calibration with minimal improvement. 40m and higher bands (in
frequency) worked OK (no overshoot) while lower bands still faulted.
I finally performed an EE INIT, reloaded 5.60 firmware, and the last saved
configuration. I later upgraded to the beta 5.64 firmware. Neither
firmware version resulted in overshoot after the EE INIT. The rig has
operated normally over the last week. I can now rest without worries (about
the K3 and its performance at the upcoming FD).
Save your current K3 configuration and try an EE INIT. While not logical, I
did this twice before I achieved success. GL!
73, Bill, K8TE
--
Sent from:
http://elecraft.365791.n2.nabble.com/______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]