Posted by
Clay Autery-2 on
Jun 05, 2018; 7:49pm
URL: http://elecraft.85.s1.nabble.com/K3S-XREF-GPSDO-recommendation-needed-tp7641686p7641718.html
While the Bodnar GPSDO will run off "station power" as long as it sees
less than 14 vdc at the external DC (5.5mm x 2.1mm (+ to center pin)
connector, anything above 5 vdc is dumped as heat into that tiny little
chassis.
It will ALSO run fine (and preferred) at 5 volts DC from EITHER the USB
port OR the External power connector.
Here is what I do:
1) I don't have the GPSDO connected to the computer via USB when I am
not ACTUALLY setting it via software.
2) I can run it from a USB cable connected to a "charge only" port on my
computer connected hub OR from ANY port on the USB hub I use for "power
only" and no connection to a computer. BOTH of these hubs have 12 VDC
external power supplied STOCK by a 12 vdc switching PS (wall wart). "I"
power them from the station power supply (13.9 VDC) via an LM317 based
adjustable DC regulator that I set at precisely 12 VDC.
3) Alternatively, I can power the GPSDO via the Ext Power connector with
5 VDC from EITHER a USB cable hacked on one end to add the 5.5mm x 2.1mm
connector (to the aforementioned USB hubs), OR via a twisted pair cable
with 5.5mm x 2.1mm connector on one and and the other end terminated to
connect to the 5VDC output of the regulator I mentioned earlier that
primarily powers the HP 58516a GPS Antenna Splitter/amp.
Bottom line... I eliminated the switching supplies from the picture and
feed the GPSDO 5vdc to minimize the waste heat dumped into the GPSDO
chassis.
As an aside, and verified with Leo Bodnar, you can switch the GPSDO from
computer connected to power ONLY WITHOUT cold booting the device (you do
not have to power it down). With the unit connected to the computer via
USB, simply connect some other 5vdc power source to the Ext Power
connector (USB or other as described above) You now have 5 vdc going to
both USB and Ext Pwr connectors. THEN, disconnect the USB connection to
the computer. The unit is now on EXTERNAL DC only, no data/computer
connection.
I then perform an additional step... I plug a pwer only connection BACK
into the USB connector (to a charging-only or a power-only USB hub/power
bus), and then remove the power cable from the Ext Pwr connector.
Why? To remove the possibility that the computer connection might feed
something back into the GPSDO and affect its frequency outputs.
73,
______________________
Clay Autery, KY5G
(318) 518-1389
On 06/05/18 09:31, Grant Youngman wrote:
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]