Re: K3 TX Calib Dummy Load Recommendations
Posted by
Bill Frantz on
Aug 26, 2018; 12:50pm
URL: http://elecraft.85.s1.nabble.com/K3-TX-Calib-Dummy-Load-Recommendations-tp7644681p7644689.html
For my KX3, I built a dummy load from three 150 ohm 2 watt
resistors and a BNC connector. The resistors are in parallel
with a lead going to the center conductor of the connector. The
other leads are folded back over the resistors and attached to
the ground-side of the connector. The whole outside is then
covered with a piece of coax braid. It does well on the antenna
analyser test Bob, K4TAX suggests.
It lives in a pocket of Rose's case and goes where the radio goes.
73 Bill AE6JV
---------------------------------------------------------------------------
Bill Frantz |"After all, if the conventional wisdom was
working, the
408-356-8506 | rate of systems being compromised would be
going down,
www.pwpconsult.com | wouldn't it?" -- Marcus Ranum
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]