http://elecraft.85.s1.nabble.com/Slightly-Unbalanced-dipole-tp7648044p7648089.html
An array of dipoles are common for high power international broadcast stations. They accept a VSWR of about 2:1 from aprox 20 DB gain curtain arrays They almost always use open wire line. It’s mostly about TX output matching.
> On Jan 13, 2019, at 9:40 PM, Barry <
[hidden email]> wrote:
>
> Don et al,
> I sense this discussion is targeting the use of a dipole on a single band. What is being missed is that many of us use a dipole cut for for one band and use it for the bands above. What we see are high SWRs on all of the higher frequency bands. We use balanced feeds, open wire or ladder line, as far as we can before we transition to coax. That transition is a good current balun. What this does is control losses due to high SWR and keeps RF currents off the outside of the coax shield. What has been said in previous notes might be true, but they will prevent or make use of balanced feeders quite difficult.
>
> An 80 meter dipole used on 40 or 20, for example, is a pretty good antenna. However, it begs to be fed with open wire or equal. That means no balun can be used at the antenna feed point. The exception is to use very expensive coax. :-)
>
> 73,
> Barry
> K3NDM
>
> ------ Original Message ------
> From: "Don Wilhelm" <
[hidden email]>
> To:
[hidden email]
> Sent: 1/13/2019 6:59:18 PM
> Subject: Re: [Elecraft] Slightly Unbalanced dipole?
>
>> Al,
>>
>> If not placed at the antenna feedpoint (up at the antenna), then the feedline may radiate due to common mode current.
>> For feedlines using parallel conductors, the problem is not as bad if the feedline exits at right angles from the radiator for at least a half wavelength. In that case, the common mode choke can be placed at the junction of the parallel line and coax.
>>
>> In all cases of a radiator fed with coax, a good common mode choke at the radiator feedpoint is necessary. Even though the RF on the inside of the coax is balanced, when the coax reaches the radiator, the side of the antenna connected to the coax shield sees two paths. One is the side of the radiator, and the other is the outside of the coax braid - it will dutifully split to follow both paths depending on the impedance of each one. A good common mode choke will prevent the RF current from seeing the coax shield as another conductor.
>>
>> A similar situation exists at the transition between parallel feedline and coax.
>>
>> 73,
>> Don W3FPR
>>
>>
>> On 1/13/2019 6:42 PM, Al Lorona wrote:
>