Re: K2: I killed my KPA100

Posted by Jim KO5V on Feb 07, 2019; 6:50pm
URL: http://elecraft.85.s1.nabble.com/K2-I-killed-my-KPA100-tp7648715p7648774.html

Don,

OK, I again thoroughly checked the PP connectors and the fuse/fuse holder, they're good, so I decided to remove the cable from the power supply, and the bolt negative output of the Tripp-Lite rotated. I opened it up and found the insulating washer was broken. I need to go to the hardware store and get a couple of new washers, but I'll bet that's the problem. It would run my LP100 when it was the only thing connected, but that draws little current. I just assumed the problem was my work - and it may still be! I'll let you know what happens after I repair the supply.

Thanks for your patience. 73,

Jim KO5V


-----Original Message-----

>From: Don Wilhelm <[hidden email]>
>Sent: Feb 7, 2019 11:00 AM
>To: Jim KO5V <[hidden email]>
>Subject: Re: K2: I killed my KPA100
>
>Jim,
>
>All that says the KPA100 should be OK, check the Anderson Power poles
>for proper insertion of the contact blades both on your power cable and
>on the KPA100.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [hidden email]