http://elecraft.85.s1.nabble.com/K2-I-killed-my-KPA100-tp7648715p7648776.html
> Don,
>
> It is all working again!
>
> The power supply's negative terminal was the problem. The terminal wan't falling off, but the internal side of the plastic feed-thru washer had cracked, and about half fell off inside. That caused it to loosen up slightly. Without the KPA hooked up, it supplied the LP-100 with enough current, and it measured the correct voltage, so I assumed it was OK, and eliminated it.
>
> I also mentioned that I was having trouble getting the K2 to communicate with a logging program, and again, I was convinced that my home-built multi-cable assembly was the culprit. It is now working. I replaced the BRAND NEW 6' long DB9 to DB9 serial cable (purchased from a "large on-line retailer"), with an old one I bought years ago at Radio Shack.
>
> I have a lot of experience that tells me that I should check my work first, but now I know not to trust everything else - even if it is new.
>
> Thanks again for your help. 73,
>
> Jim KO5V
>
>
>
>> -----Original Message-----
>>> From: Don Wilhelm <
[hidden email]>
>>> Sent: Feb 7, 2019 12:22 PM
>>> To: Jim KO5V <
[hidden email]>
>>> Subject: Re: K2: I killed my KPA100
>>>
>>> Jim,
>>>
>>> That certainly could cause the problem.
>>>
>>> 73,
>>> Don W3FPR
>>>
>>> On 2/7/2019 1:50 PM, Jim KO5V wrote:
>>>> Don,
>>>>
>>>> OK, I again thoroughly checked the PP connectors and the fuse/fuse holder, they're good, so I decided to remove the cable from the power supply, and the bolt negative output of the Tripp-Lite rotated. I opened it up and found the insulating washer was broken. I need to go to the hardware store and get a couple of new washers, but I'll bet that's the problem. It would run my LP100 when it was the only thing connected, but that draws little current. I just assumed the problem was my work - and it may still be! I'll let you know what happens after I repair the supply.
>>>>
>>>> Thanks for your patience. 73,
>>>>
>>>> Jim KO5V
>>>>
>>>>
>>>> -----Original Message-----
>>>>> From: Don Wilhelm <
[hidden email]>
>>>>> Sent: Feb 7, 2019 11:00 AM
>>>>> To: Jim KO5V <
[hidden email]>
>>>>> Subject: Re: K2: I killed my KPA100
>>>>>
>>>>> Jim,
>>>>>
>>>>> All that says the KPA100 should be OK, check the Anderson Power poles
>>>>> for proper insertion of the contact blades both on your power cable and
>>>>> on the KPA100.
> ______________________________________________________________
> Elecraft mailing list
> Home:
http://mailman.qth.net/mailman/listinfo/elecraft> Help:
http://mailman.qth.net/mmfaq.htm> Post: mailto:
[hidden email]
>
> This list hosted by:
http://www.qsl.net> Please help support this email list:
http://www.qsl.net/donate.html> Message delivered to
[hidden email]
>