http://elecraft.85.s1.nabble.com/Elecraft-K3s-etc-bonding-tp7659942p7660011.html
I use thin, flat, copper strips. I use a paper punch to make neat holes
in them. You can stack a whole bunch of them on a terminal. They are a
CWops no. 5
> I'm currently in the process of wiring up my new station and I happen to
> be working on the equipment bonding phase for my pair of K3s SO2R
> station. I'm doing my best to get decent connectivity between the
> station components, but can't really figure out how to terminate large
> (AWG 10) wire to the teeny 6-32 ground screws on the back of the K3,
> especially since something like six bond wires need to be attached to
> the transceivers. There appear to be no available ring terminals that
> will fit these small screws; the smallest I can find are for #10 studs.
> Even by using a threaded standoff installed in the K3 ground nut and a
> longer screw to stand the rings off, stacking a bunch of these huge
> terminals is extremely difficult. Providing some means of reasonably
> quick disconnect for servicing purposes is equally difficult. Exactly
> how can I go about connecting big wires to little ground posts?
>
> 73...
> Randy, W8FN
>
> On 4/20/2020 10:22 PM, Jim Brown wrote:
>> On 4/20/2020 6:08 PM, Tom Norris NB5Q wrote:
>>> I'm asking what method and
>>> attachment point, to each piece of equipment, you experienced K-Line
>>> owners
>>> use to bond the K3s, P3, SP3, etc. and then on to the station ground.
>>
>> I use wires soldered to screw lugs, making sure that the attachment
>> point is not insulated from the chassis by paint. Some of the
>> equipment has a dedicated grounding screw. Shells of DB connectors
>> SHOULD be bonded to the equipment chassis, but not always -- some mfrs
>> screw up and fail to do that.
>>
>> Some of my equipment goes out in the field from time to time, so I use
>> single circuit Power Pole connectors to make that easy. I'll use 2-6"
>> between the lug and the PowerPole, then make a loop soldered to a
>> PowerPoles that connect to each piece of gear in the string (so each
>> connector has two wires). There are lots of suitable variations on
>> this, depending on how the shack is laid out.
>>
>> These are the slides for my talks on station power, grounding, and
>> bonding.
http://k9yc.com/GroundingAndAudio.pdf>>
>> 73, Jim K9YC