Re: K3S TX current
Posted by
Randy Farmer-2 on
Sep 06, 2020; 6:26pm
URL: http://elecraft.85.s1.nabble.com/K3S-TX-current-tp7664737p7664754.html
The K3 PA is the original module, but I don't know what devices it uses.
Perhaps someone with inside knowledge could provide a S/N range or
approximate date for the changeover. I built my K3 from a kit in July
2009. As I recall, It draws about 17.5A with key-down CW on 20 meters.
The K3S PA module was replaced in July 2016. I don't know if the
original K3S PA showed the elevated current draw before it was replaced.
73...
Randy, W8FN
On 9/6/2020 2:07 PM, ab2tc wrote:
> Hi Randy,
>
> Does your K3 #3260 have the newer MOSFET PA? I believe the K3 switched the
> PA from bipolar to the newer MOSFET design at some point (mine is #82!). I
> agree with you that the 20/30m LPF ought to be a prime suspect. Everything
> else is common and 14MHz should be very close to the center of the total
> frequency range of the transmitter. My K3S has not had any reliability
> problems either, but it sees fairly light duty with SSB only and no heavy
> duty "run mode" contest use.
>
> BTW, I checked the current draw on 30m (on the K3S) which *shares the same
> LP filter*. It is an average 17.5A. But 30m is lower in frequency and thus
> farther away from the filter cutoff. 40m, 15m and 10m LP filters are also
> shared with a lower frequency band, but do not cause an elevated current
> draw.
>
> Knut - AB2TC
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.htmlMessage delivered to
[hidden email]