tune pwr

[Todd Ruby]

I have just put the K3 on the air for the first time after  
downloading all firmware upgrades. When I hold TUNE pwr is at 0 and  
rotating the PWR ctrl gets it to a desired output just fine. when i  
go to retune it is back at 0 watts and I have to rotate the PWR knob  
each time. What is the way to have the PWR be at least set to where  
it was previously?

tnx in advance




73
de
todd
WB2ZAB

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[N8XPQ]

Yes,

Hold down the menu key to enter the config menu. Rotate VFO B knob until you find TUN PWR set this setting to your desired tune power. I hope this helps.

Mike N8XPQ

Todd Ruby wrote

I have just put the K3 on the air for the first time after  
downloading all firmware upgrades. When I hold TUNE pwr is at 0 and  
rotating the PWR ctrl gets it to a desired output just fine. when i  
go to retune it is back at 0 watts and I have to rotate the PWR knob  
each time. What is the way to have the PWR be at least set to where  
it was previously?

tnx in advance




73
de
todd
WB2ZAB

_______________________________________________
Elecraft mailing list
Post to: [e-mail]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com