unusual problem

classic Classic list List threaded Threaded
2 messages Options
Reply | Threaded
Open this post in threaded view
|

unusual problem

Lou Kolb
Recently, I started noticing a strange sound from my K3-4290.  When keying
the rig on CW I'll hear a crackling or almost a gurgling sound coming from
the radio itself.  It's only happened 2 or at most 3 times but this morning
I smelled something for the first time.  It started happening right after I
upgraded the firmware although I doubt there's a connection.  I'm guessing a
coil could be arcing, although as a person who is blind, I'm afraid I can't
offer any visual data.  Any thoughts?  Lou WA3MIX

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: unusual problem

Lou Kolb
Sam,

Not sure which accessory is the KXV3a.  I do have the internal tuner and a
G5RV  and a tribander hooked to the A and B antenna jacks.  I have no amp
and use the G5RV most of the time.  I should also mention that everytime
this has happened, it's been right after turning the rig on after it has
been sitting overnight in a chilly shack.  It'll arc for a few seconds, only
while transmitting, and then settle down.  So far, I haven't noticed any
other anomales in the operation of the rig.  Lou WA3MIX
----- Original Message -----
From: "Sam Morgan" <[hidden email]>
To: "Lou Kolb" <[hidden email]>
Sent: Saturday, December 11, 2010 8:01 AM
Subject: Re: [Elecraft] unusual problem


> Do you have the KXV3A in your K3?
> I had the KXV3A in mine and added an antenna to the RX ANT IN
> Then I transmitted on another antenna.
> Everything was fine when running 100w.
> Then I turned on my Ameritron AL-811 amp.
> When I transmitted I heard a sizzling sound,
> and smelled something burning.
>
> It turns out my RX antenna was to close to my TX antenna.
> The result was the GAP 1 melted the solder holding it.
> It then dropped on the top of the relays on the KXVA3 board.
> Since the GAP 1 is ceramic,
> the heat from it melted the plastic case on the relays,
> causing the burnt electronics smell.
>
> The rig continued to work, but the RX antenna no longer worked.
> Perhaps this is your problem?
>
> GB & 73
> K5OAI
> Sam Morgan
>
> On 12/11/2010 6:36 AM, Lou Kolb wrote:
>> Recently, I started noticing a strange sound from my K3-4290.  When
>> keying
>> the rig on CW I'll hear a crackling or almost a gurgling sound coming
>> from
>> the radio itself.  It's only happened 2 or at most 3 times but this
>> morning
>> I smelled something for the first time.  It started happening right after
>> I
>> upgraded the firmware although I doubt there's a connection.  I'm
>> guessing a
>> coil could be arcing, although as a person who is blind, I'm afraid I
>> can't
>> offer any visual data.  Any thoughts?  Lou WA3MIX
>>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html