w1 and 160 module

[George Cortez Jr]

If I  didnt want to use the 160 rx connector, could you leave w1 in
place with no ill effect?

George NE2I


_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

[Don Wilhelm-3]

George,

Sorry, but no - the entire K160RX will not work, and that means no RF output
on 160 meters even if the K2 says it is operating on 160 meters.

If you do not wish to use the RX jack, just leave the BNC connector off -
but then, it is not hard to put it on, so why not just do the complete job?
The RX ant will not be active until you turn it on in the K2 menu.

73,
Don W3FPR

> -----Original Message-----
>
> If I  didnt want to use the 160 rx connector, could you leave w1 in
> place with no ill effect?
>
> George NE2I
>
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.10.13/78 - Release Date: 8/19/2005

_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft   

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com