Tom,
The K3 EXT ALC input is on the ACC connector at pin 15 - see the manual
page 18 for the ACC connector.
The "how to use" is in page 27.
It is likely that you do not need to use the ALC from the amp - the amp
ALC should not be used to control the power output from the K3, but if
your amp uses ALC to reduce power from the exciter because of an amp
fault, that is a valid use of the ALC line.
73,
Don W3FPR
On 9/14/2011 10:30 AM, Tom wrote:
> Where do I connect the ALC from the K-3 to my amp. I' m sure it must be in the manual, but can't seem to find it.
> Tom
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html