Head Phones and a note about Replacing the KI03 I/O

classic Classic list List threaded Threaded
3 messages Options
Reply | Threaded
Open this post in threaded view
|

Head Phones and a note about Replacing the KI03 I/O

KARL MARDERIAN
   First off I ran across some people taking about Head Phones and the  
K3. If I what use a Mono pair of phones, I like the Kenwood HS-5 8  
Ohms. They are well mad and sound good. But I regress, at the end of  
replace KI03, one is told to cut both traces on the RF board, from the  
bottom of the radio. They state if cut properly, you should read "0"  
ohms on your meter. Well, I got reads of between 12-14 ohms. Is there  
not all kinds of electric stuff on the other side of the board for the  
circuit to follow. My mag glass works just fine to show I cut the  
copper out the PC board. Just so you known
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: Head Phones and a note about Replacing the KI03 I/O

Don Wilhelm-4
Karl,

Did you cut the correct traces?
You should read "infinity" on your meter after the cut, and not "0".  
Measure across each cut - one probe on one side of the cut and the other
probe on the other side of the cut.

73,
Don W3FPR

KARL MARDERIAN wrote:

>    First off I ran across some people taking about Head Phones and the  
> K3. If I what use a Mono pair of phones, I like the Kenwood HS-5 8  
> Ohms. They are well mad and sound good. But I regress, at the end of  
> replace KI03, one is told to cut both traces on the RF board, from the  
> bottom of the radio. They state if cut properly, you should read "0"  
> ohms on your meter. Well, I got reads of between 12-14 ohms. Is there  
> not all kinds of electric stuff on the other side of the board for the  
> circuit to follow. My mag glass works just fine to show I cut the  
> copper out the PC board. Just so you known
>  
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Reply | Threaded
Open this post in threaded view
|

Re: Head Phones and a note about Replacing the KI03 I/O

AC7AC
In reply to this post by KARL MARDERIAN
CONTENTS DELETED
The author has deleted this message.