Do you have the jumper on the 3 pin header near the BNC jack placed
correctly? It should be on the KAT1 position if the KAT1 is installed
or in the K1 position without the KAT1.
If it is not placed correctly, the power control will not be correct and
the display will show zero power (actually it will read 0.1).
If the jumper is correct, and you still have problems, check the two 1%
resistors on the bottom of the board near the BNC jack (in the corner of
the RF Board).
73,
Don W3FPR
On 5/25/2011 12:26 PM, Don Baucom wrote:
> I finished my K1 works great, I see I am getting 5 watts out on my SWR
> meter.. I have made several QSO's already.. My problem is during alignment
> the power meter always said P=0.1 no matter what I did. Also when I transmit
> I do not see the bars that are supposed to show a bar per watt. I do see a
> random numer pop on the dispaly every now and then when I transmit. one time
> it was 13.6 another time 20 something. It does not happen all the time. I
> have alligned the swr meter so I do not think that has any bearing.
>
> Any Ideas?
>
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html
Locked
