K2 cntrl brd res reading

[John Cooper]

K2 control board all resistance readings ok cept I get 95 k for U6 pins 29 30 which call for 70-90k.

WT5Y

Sent from my Cricket smartphone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Christophe F8ACF-56]

Good evening to all,

the values ​​are correct here was also "95 K" and everything works fine

K2 # 7369 10 to 100 W in progress


 
73 , Christophe F8ACF-56


________________________________
 De : wt5y <[hidden email]>
À : [hidden email]
Envoyé le : Lundi 25 novembre 2013 20h28
Objet : [Elecraft] K2 cntrl brd res reading
 


K2 control board all resistance readings ok cept I get 95 k for U6 pins 29 30 which call for 70-90k.

WT5Y

Sent from my Cricket smartphone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Don Wilhelm-4]

John,

That is just fine.  I know a range was specified, but you are only 6%
out of that range and normally a 10% variation is acceptable.

In the case of those particular signals, they are connected only to the
P3 connector at this time, so your ohmmeter is reading only the
resistance displayed by U6 itself, and the actual reading is dependent
on which particular ohmmeter is being used.

73,
Don W3FPR

On 11/25/2013 2:28 PM, wt5y wrote:

> K2 control board all resistance readings ok cept I get 95 k for U6 pins 29 30 which call for 70-90k.
>
> WT5Y
>
> Sent from my Cricket smartphone
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[hidden email]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html