You are fine.
Fire it up.
73,
Steve
NN4X
On Wed, Jan 21, 2009 at 10:04 PM, Walter V. Gilles
<[hidden email]> wrote:
|
Greetings,
K3/100 assembly in work. I just did the four resistance checks that verify the power buses are not shorted to ground. All R measurements exceeded the minimums specified. However, that kind of leaves a big range of what constitutes "nominal" values. Can anybody provide what are typically nominal values for these? Below are what I measured on my particular K3 with respect to minimums required.
1. 12VDC IN connectors. Required: >50K ohms Measured: >20M ohms (out of range)
2. Between R36 (test point) and ground. Required: >150 ohms Measured: 234 ohms.
3. Between U12 (test point) and ground. Required: >500 ohms Measured: 4.8K ohms.
4. Between U13 (test point) and ground. Required: >150 ohms Measured: 423 ohms.
Thanks much. Any advice appreciated.
Walter, N0DZJ |
_______________________________________________
Elecraft mailing list
Post to: [hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to:
[hidden email]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help:
http://mailman.qth.net/subscribers.htmElecraft web page:
http://www.elecraft.com
Locked
