Is there a simple way to reset all the configuration parameters to the factory defaults
with out going through each item? Jay |
You can reset everything by the following: Power off Hold in shift knob while pressing power on switch unit it fully powers up You will have to start over again just like you had just finished building it - so don't so this just for grins. If you have an older configuration file saved you can reload it and be right back where you were when you saved the file. The firmware is not affected either way - kinda like a restore point in Win XP. Good luck! Gill |
Perhaps I stated the question incorrectly.
Is there a list of the factory default parameters in the configuration, so that one can compare the default to the present setting. Jay ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
Jay,
Yes, it is easier than a list. Enter the menu and tap the DISP button - the default setting will be displayed in the VFO B area. 73, Don W3FPR Jay Rodaman wrote: > Perhaps I stated the question incorrectly. > Is there a list of the factory default parameters > in the configuration, so that one can compare the default > to the present setting. > > Jay > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
In reply to this post by JayR
When in the CONFIG mode, simply tap the DISP button and you will see the
"Default" value for the selected parameter. It is also in the manual for each parameter. 73, Ken K3IU ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ On 12/23/2009 9:29 PM, Jay Rodaman wrote: > Perhaps I stated the question incorrectly. > Is there a list of the factory default parameters > in the configuration, so that one can compare the default > to the present setting. > > Jay > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
In reply to this post by JayR
G'day,
Yes, both within the radio and in the handbook "Menu Functions". Sadly reading the handbook to find out how to use the radio and how to connect it to the outside world is a minority pastime. Regards, Mike VP8NO ----- Original Message ----- From: "Jay Rodaman" <[hidden email]> To: "'Gill W4RYW'" <[hidden email]>; <[hidden email]> Sent: Wednesday, December 23, 2009 11:29 PM Subject: Re: [Elecraft] K3 Configuration Reset > Perhaps I stated the question incorrectly. > Is there a list of the factory default parameters > in the configuration, so that one can compare the default > to the present setting. > > Jay ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[hidden email] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html |
Free forum by Nabble | Edit this page |