I would think the firmware makes that
determination. It always starts out
using 5 watts and I see it jump to 10
watts just before finishing.
KenK3IU
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
On 10/4/2010 7:29 AM, Sam Morgan wrote:
> I see in the manual, under CONFIG TUNE
> it says:
> "Note1: TUN PWR does not pertain to ATU TUNE , which always uses 5
> or 10 W and is internally controlled."
>
> what determines if 5 or 10 watts is being used?
______________________________________________________________
Elecraft mailing list
Home:
http://mailman.qth.net/mailman/listinfo/elecraftHelp:
http://mailman.qth.net/mmfaq.htmPost: mailto:
[hidden email]
This list hosted by:
http://www.qsl.netPlease help support this email list:
http://www.qsl.net/donate.html