K3 MEMORY USE

[Mike K4PI]

I noticed when using my memories on the K3, the keying line to the amp drops in between some words.  Even if I hold the foot switch down it will not hold he relay in.  If I try to invoke the XMIT switch during the memory run that kicks the memory our of run mode.    Of course I could run CW speed at a higher rate but sometimes it needs to be run slower.  Any way to keep the amp keying line invoked the whole time the memory is running? 73 Mike K4PI
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Richard Ferch]

You could try increasing the VOX delay.

73,
Rich VE3KI

K4PI wrote:

> I noticed when using my memories on the K3, the keying line
> to the amp drops in between some words.  Even if I hold the
> foot switch down it will not hold he relay in.  If I try to
> invoke the XMIT switch during the memory run that kicks the
> memory our of run mode.   Of course I could run CW speed at
> a higher rate but sometimes it needs to be run slower.  Any
> way to keep the amp keying line invoked the whole time the
> memory is running?
>
> 73 Mike K4PI

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[hidden email]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

[Mike K2MK]

Hi Mike,

Is it possible you have QSK (Full break-in) active instead of VOX (Semi break-in).

73,
Mike K2MK

Mike K4PI wrote

I noticed when using my memories on the K3, the keying line to the amp drops in between some words.  Even if I hold the foot switch down it will not hold he relay in.  If I try to invoke the XMIT switch during the memory run that kicks the memory our of run mode.    Of course I could run CW speed at a higher rate but sometimes it needs to be run slower.  Any way to keep the amp keying line invoked the whole time the memory is running? 73 Mike K4PI